Measuring Microbial Communities' Biomass

From Soil Ecology Wiki
Jump to navigation Jump to search

To sample microbial communities’ biomass there are two approaches. The two approaches include several different methods. These approaches are either direct or indirect sampling techniques [2]. Directing sampling involved counting while indirect sampling involves the use of chemicals [2].

Direct

Agar Plates

Outlined by Jones et al (1948) the use of agar plates was used to count organisms in microscopic fields [3]. Soil samples are first taken at random and sifted through a sieve and then weighed out [3]. Following this the sample is then put into a crucible with sterile distilled water and ground up with a glass rod [3]. The sample is then washed with sterile distilled water with the suspended matter poured into a flask [3]. The soil suspension is then made up to 50ml with 1.5% being agar [3]. Once this is done the flask is shaken and left to rest for a short period. Once rested using a pipette the samples are taken and put on a slide [3]. Once the slide is prepared it is then put into sterile distilled water [3]. Once dried the sample can then be put under a microscope to count organisms [3].

Extractable DNA

Torsvik et al (1990) used the extractable DNA to determine the identities of organisms in soil samples [2]. Six 30g soil samples were first prepared. Following this samples were washed with 2% sodium hexametaphosphate to increase the yield of DNA [6]. This allows for the extraction of naked DNA adsorbs to colloids [6]. The suspensions are then stored in a refrigerator and the pellets were stored in isopropanol [6]. Pellets are then centrifuged, suspended in a buffer, and then homogenized to lyse the soil bacteria [6]. Following this the volume is adjusted to 25ml using a buffer and then incubated for one hour [6]. Then 2 mg of proteinase K ml-1 was added and then incubated for another hour [6]. The suspension is then heated to 60oC, sodium dodecyl sulfate was added, and then incubated for five minutes [6]. The lysate was then, KCl was added, refrigerated overnight, and then centrifuged [6]. The supernatants were pooled and purified on a hydroxyapatite (HAP) column [6]. DNA from the pooled fractions were then concentrated by cetylpyridinium bromide precipitation to purify the DNA [6].

Signature Lipid Biomarkers (SLB)

This technique involves the measurement of ester-linked polar lipid fatty acids and steroids to find microbial biomass and community structure [2]. A common biomarker used for this technique are phospholipids fatty acids (PFLAs) [2]. The total number of PFLAs provides quantitative measure of viable or potentially viable biomass []. When a cell dies the cellular enzymes hydrolyze and release a phosphate group. The remaining lipid is then compared to the ratio of PFLAs to the remaining lipid []. This provides evidence of viable and non-viable microbes [].

Indirect

Chloroform Fumigation and Incubation (CFI)

The Chloroform fumigation and incubation method (CFI) is used to determine organic C biomass in soil microbials. Chloroform vapor is used to fumigate soil []. Once the soil is fumigated the (CHCl3) vapor is removed then the soil is incubated []. Evolved (CO2) levels are then measured for both fumigated and then unfumigated soil to calculate biomass []. Using the expression B=F/kc (B=soil biomass C, F= carbon dioxide carbon evolved by fumigated soil minus (CO2) evolved by unfumigated soil, and kc= fraction of biomass mineralized to (CO2) during the incubation) biomass can be calculated where (kc) is a constant [2]. Voroney and Paul (1984) then furthered this technique to include labile nitrogen and measured the fraction of biomass nitrogen (kn) mineralized to inorganic nitrogen [].